Product Introduction:

HDM-QD330 synthetic heat transfer oil is a synthetic heat transfer oil made of alkyl benzene base oil, high-performance biphenyl materials and various high-temperature additives, which has the properties of thermal cracking and oxidation resistance. The product has good heat transfer efficiency, and its excellent viscosity characteristics make it easy to pump at startup and operating temperature. Because of their thermal cracking resistance at the recommended operating temperature, the flash points of these oils will not be significantly reduced in use. The product also shows special heating and heat conduction characteristics, and the heat dissipation is faster. Closed and open cold oil seal indirect heating and cooling systems for various industrial processes are recommended.

Application scope:

HDM-QD330 synthetic heat transfer oil is suitable for closed heat transfer system with heating temperature lower than 325℃

Performance characteristics:

• Narrow fraction range and high initial boiling point.
• Good oxidation stability at high temperature and long service life.
• Low volatility and good fluidity at low temperature.
• High specific heat capacity. Good thermal conductivity
• Good compatibility with system materials, non-corrosive.

Technical specifications:

• GB 23971-2009
• DIN 51522-1998

Typical data:

Note: The above data are the measurement results of representative styles, and the product performance is subject to the actual measurement.

Caution:

According to the equipment oil regulations, select the oil with appropriate quality grade and viscosity grade; The storage container must be dedicated, and it must be waterproof, moisture-proof and prevent mechanical impurities from mixing during storage and transportation; Prevent foreign body pollution; Prevent contact with other oils

Products shall be mixed, and different types of lubricating oil shall not be mixed.

Packing: 200L iron drum and 18L plastic drum.